Visonic KP-250 PG2 - Time and Date Configuration

6. System Configuration
D-304269 KP-250 PG2 User’s Guide 33
☺ Go to step 3
DELETE
KEYFOB
A "Happy Tune" ☺ sounds and the display reads [ DELETE KEYFOB ] and
returns to step 3.
14
Additional Information (section B.7)
1
For detailed instructions on how to select User Settings – refer to section A.1 and
section A.2.
2
The LED will extinguish after several seconds. In case of difficulties in communication with the control panel, the
LED may blink for several seconds more while trying to establish communication. During this period of time the
keyfob keys are disabled.
3
The display shows the first enrolled Keyfob (Keyfob No.1) of the 8 (PowerMaster-10) / 32 (PowerMaster-30 G2 /
PowerMaster-33 G2) keyfobs.
4
To abort enrollment, press the button.
5
If Partition is enabled, continue to step 6.
6
You can now enroll another keyfob. You can also select another option in the User Settings menu (see section A.1
and section A.2), or quit programming (see section A.3).
7
If the keyfob was previously enrolled in the system, the KP-250 PG2 display indicates this together with the
keyfob's ID number, for example, " ALREADY ENROLLED F01:KEYFOBS".
8
Before you delete a keyfob, identify the keyfob either by the keyfob No., for example, F06, or by the ID number of
the keyfob that appears on the display, and then make sure that it is the keyfob you wish to delete.
9
Enrollment by Device ID:
Step 4b enables you to register the device ID and to complete the programming process without being in
possession of the device itself (can also be performed off-site by the installer). Enrollment can then be completed
at a later stage by following the same enrollment procedure described in Step 3 without entering the User Settings
menu.
10
This setting can be performed only after completing steps 1 - 5 of section B.7A.
11
The box symbol now appears next to the newly selected Partitions.
12
You can now repeat steps 2 - 8 to program or edit another keyfob.
13
To abort the procedure, press the button.
14
You can now add or delete another keyfob or select another option in the User Settings menu or quit
programming (see sections A.1 and section A.2).
B.8 Setting the Time & Time Format
 Here you can program or adjust the built-in-clock to show the correct time in the desired time format.
 You can select between a 24 hour and a 12 hour (AM/PM) time format.

Carefully read the section titled "Additional Information" according to the indicated references
1
etc – see table
at end of this section.