Visonic KP-250 PG2 - Advanced Features; Control Options and Pushbuttons

7. Advanced Features
48 D-304269 KP-250 PG2 User’s Guide
9.
KP250 cat.number
70245100
Displays the KP-250 PG2 keypad catalog number.
10.
RSU VERSION
7S702415 K01.034
Displays the software upgrade communicator version
11.
BOOT VERSION
7S702412 K01.022
Displays the software upgrade boot/programmer version
Return to step 2
3
,
4
Additional Information (section B.17)
1
For detailed instructions on how to select the Setting Options – refer to section A.1 and section A.2.
2
Refers to PowerMaster-30 G2 only.
3
To end this session and return to previous menu options, press the button.
4
You can now select another option in the User Settings menu (see section A.1 and section A.2), or quit
programming (see section A.3).
7. Advanced Features
Control Options and Pushbuttons
The system allows manual or automatic remote control of a device connected to the PGM output.
The user defines the ON and OFF times via the Scheduler (see Chapter 6, B.14 Programming the Scheduler). The
installer determines which zone sensors will switch the remote controlled appliances on and off. However, the decision
whether the remote controlled appliance will respond as programmed is up to you (see next table).
Key Function
Manual activation of a light or other household electrical appliance that is connected to PGM output.
Manual deactivation of a light or other household electrical appliance that is connected to PGM output.
Selecting the active automatic control method:
 Sensors: The appliance is controlled by sensors (assigned by the installer for this).
 Timer: The appliance is controlled by timer (ON and OFF times are defined by the installer).
 Both: The appliance is controlled by sensors as well as by a timer.
Examples of benefits gained by automatic remote control:
 Timer Control. When you are away, the timed activation / de-activation of an electrical appliance.
 Zone Control. Upon disturbance of a perimeter zone, the electrical device is switched on.
Note: Automatic activation and deactivation of electrical appliance depends also on the Scheduler setup (see
Chapter 6, B.14 Programming the Scheduler).