Visonic KP-250 PG2 - Reviewing the Zone Bypass Scheme; Recalling the Zone Bypass Scheme

6. System Configuration
24 D-304269 KP-250 PG2 User’s Guide
B.2 Reviewing the Zone Bypass Scheme
 Here you can quickly review the Bypass Scheme i.e. the zones that are set to be bypassed during the next arming
session.
1.
REVIEW BYPASS
Enter the [USER SETTINGS] menu and select the [REVIEW BYPASS]
1
option and
press .
2
2.
BYPASS LIST
The display reads [BYPASS LIST]
or Click the or buttons repeatedly to review all bypassed zones in
ascending numerical order. When done, click to exit.
9
3.
Z04: BYPASSED
Z04: P1

P2 P3
Kitchen
B.3 Recalling the Zone Bypass Scheme
 Use this option to repeat (recall) the most recent Bypassed Scheme for use during the next arming session.
1.
RECALL BYPASS
Enter the [USER SETTINGS] menu, select the [RECALL BYPASS]
1
option and
press .
2, 6
2.
<OK> TO RECALL
The display now reads [<OK> TO RECALL].
7
To recall the last used bypass scheme press .
BYPASS RECALLED
A "Happy Tune" ☺ sounds. The display reads [ BYPASS RECALLED ] and then
returns to “ USER SETTINGS " step 1.
9
☺ Return to step 1
Additional Information (section B.1 – B.3)
1
For detailed instructions on how to select User Settings – refer to section A.1 and section A.2.
2
This menu is displayed only if "BYPASS" was previously enabled by the installer.
3
The STATUS to the right of the zone number indicates whether the zone is READY, NOT-READY or
BYPASSED.
4
This display will appear only if PARTITIONING was previously enabled.