6. System Configuration
D-304269 KP-250 PG2 User’s Guide 27
B. To Set Partitions Authorization
Additional Information (section B.4)
1
For detailed instructions on how to select the setting options – refer to section A.1 and section A.2.
2
The display shows the 1
st
User Code (Master User) in the list of 8 (PowerMaster-10 G2) / 48 (PowerMaster-30
G2 / PowerMaster-33 G2) User Codes. If you have not yet changed the default code 1111, we recommend that
you change it now.
3
a. The display shows the user code currently programmed in this location (e.g. 5327).
b. The cursor blinks on the first digit of the code.
c. If the location is free the display will be (0000).
4
You can move the cursor to the next or previous digit by pressing or . Pressing erases the
digit of the cursor + all digits to the right of the cursor.
5
a. The new code is momentarily displayed without the cursor before reverting to step 3.
b. If Partition is enabled, continue to step 6.
6
You can now repeat steps 3 - 5 to program or edit another user code. To end this session and to select other
menu options or to quit programming – follow the instructions in section A.2.
7
This setting can be performed only after completing steps 1 - 5 of section B.4A.
8
At this stage, pressing the button continuously switches between the first and second rows.
9
You can now repeat steps 3 - 7 to program or edit another user code.
B.5 Programming the Duress Code
A duress (ambush) alarm message can be sent to the Monitoring Station if you are forced to disarm the system under
violence or menace. To initiate a duress message, you must disarm the system using a duress code (2580 by default)
Here you program the duress code.
Carefully read the section titled "Additional Information" according to the indicated references
1
etc – see table at
end of this section.
Refers to when PARTITIONING is enabled.
6.
User 06: 1234
1
2 3
The display will now enable you to set the partitions.
7
7.
User 06: 1234
1
2 3
Press the button and use the keypad keys , , to change the status
of the partitions 1, 2 & 3, respectively.
8
When you are satisfied with the setting, for example, User 6 is authorized with
Partition 1 and 3 only, press to confirm.
☺ Return to step 3 A "Happy Tune" ☺ sounds. The display confirms the Partition setting.
9
To Next Page
Loading...
