6. System Configuration
26 D-304269 KP-250 PG2 User’s Guide
User Codes 5-8 (PowerMaster-10 G2) / User Codes 23-32 (PowerMaster-30 G2 / PowerMaster-33 G2) are the
same as user codes 2-4 (PowerMaster-10 G2) / 2-22 (PowerMaster-30 G2 / PowerMaster-33 G2) but can be assigned
to "Latchkey" (child monitor) users. For a detailed explanation of the Latchkey application see Chapter 3.
A. To Program a User Code
Partition Option (For information about Partition option - see APPENDIX B)
Your alarm system can divide zones into up to 3 parts (groups) via the installer menu. These parts are
designated as partitions P1, P2 & P3. Each partition can be armed and disarmed separately, providing protection
to selected parts of the premises.
Each user out of the 8 (PowerMaster-10 G2) / 48 (PowerMaster-30 G2 / PowerMaster-33 G2) system users can
be authorized by the Master User to arm and disarm any combination of partitions including all 3 partitions.
Here you can program (or edit) the 8 (PowerMaster-10 G2) / 48 (PowerMaster-30 G2 / PowerMaster-33 G2)
User Codes and thereby define which of these will be authorized to arm and disarm.
1. The default setting 1111 of the Master User Code is the same for all PowerMaster systems and is known to
many other people. Therefore, we highly recommend that you immediately replace it with a unique secret
code.
2. Code "0000" is not valid! Do not use it.
3. The duress code (2580 by default), which is set in the installer menu, cannot be selected as a normal user
code. Any attempt to program it will be rejected by the system.
4. Carefully read the section titled "Additional Information" according to the indicated references
1
etc – see
table at end of this section.
1.
USER CODES
Enter the [USER SETTINGS] menu, select the [USER CODES] option and press
.
1
2.
User 01: 1111
The first user code "User 01: 1111" is displayed.
2
or
At the blinking cursor position, key in the User Code you wish to program , for
example, [06] for user code 6, or alternatively click the or button until
the display reads, [User 06: 0000].
3.
User 06: 0000
When the user code you wish to program appears on the display, press .
4.
User 06: 0000
To program or edit the code, at the blinking cursor position enter the 4 digit code,
for example, “1234”, using the numerical keypad.
3,
4
5.
When done, press .
User 06: 1234
☺ Return to step 3 A "Happy Tune" ☺ sounds. The display confirms the saved code.
5,
6
To Next Page
Loading...
