Visonic KP-250 PG2 - Event Reporting Setup

6. System Configuration
D-304269 KP-250 PG2 User’s Guide 37
Additional Information (section B.10 - B.11)
1
For detailed instructions on how to select User Settings – refer to section A.1 and section A.2.
2
The display shows the current setting, for example, [AUTO-ARM enable ]. You can now select either to enable or
disable auto-arming using the or button.
3
The

symbol now appears next to the newly selected option.
4
The display shows the current setting of the Auto-Arm Time, for example, " 12:00 PM ", with the cursor blinking on
the first hour digit "1". For detailed explanation of how to set the time - refer to Section B.8B.
5
The saved auto arm time is displayed without the cursor, for example, " 08:30 A ".
6
You can now select another option in the User Settings menu (see section A.1 and section A.2), or quit
programming (see section A.3).
B.12 Programming Private Phone and SMS Reporting
The PowerMaster system can be programmed to send various event notification messages such as alarm, arming or
trouble events, to 4 private telephone subscribers by audible signal and, if a GSM option is installed, also to 4 SMS
telephone numbers. These reports can be programmed either instead of or in addition to the reports transmitted to the
monitoring company. Further details about the event notification by telephone and SMS are provided in the
PowerMaster-10/30 G2 User Guide, Chapter 7 Event Reporting and Control by Telephone and SMS.
You can also determine the number of times the private telephone number is dialed and whether a single acknowledge
signal will stop the reporting process or an acknowledge signal from each telephone will be required before the current
event is considered reported.
Here you can program:
 The specific events you wish the system to report.
 The 1
st
, 2
nd
, 3
rd
, and 4
th
private telephone and SMS numbers for reporting alarm and other event messages to
private subscribers.
 The number of redial attempts, two-way voice communication

, and whether to use a single acknowledge signal or
an acknowledge signal from each telephone before the current event is considered reported.

Carefully read the section titled "Additional Information" according to the indicated references
1
etc – see table at
end of this section.
VOICE REPORT
A. To Program Events to be Reported to private telephone
1. PRIVATE REPORT
Enter the [USER SETTINGS] menu and select the [PRIVATE REPORT] option and
press .
1
2.
VOICE REPORT
The display will read [VOICE REPORT]. To enter this option press .
3. REPORTED EVENTS
disable report
When the display reads [REPORTED EVENTS] press .
2

Refers to system that is connected to the Voice Box