Visonic KP-250 PG2 - Page 31

6. System Configuration
D-304269 KP-250 PG2 User’s Guide 31
A. To Add (Enroll) a Keyfob
1.
KEYFOBS
Enter the [USER SETTINGS] menu, select the [KEYFOBS] option and press
.
1
2.
ADD NEW
KEYFOB
The display will read [ADD NEW KEYFOB].
4
To enroll a new keyfob press .
3.
ENROLL NOW or
ENTR ID:xxx-xxxx
The display offers you two alternative methods to enroll a keyfob:
A: ENROLL NOW: Press and hold the AUX  button on the selected keyfob until
the LED is constantly on.
2
This procedure completes the enrollment.
4a.
DEVICE ENROLLED
ID No. 300-5786
If enrollment was successfully completed, a "Happy Tune" ☺ sounds and the
display reads [DEVICE ENROLLED] for a short duration and then changes to read
the keyfob's details. Continue to step 5.
DEVICE ENROLLED
F01:KEYFOB
☺ Go to step 5
4b.
ID No. 300-5786
B: ENROLLMENT BY DEVICE ID: Enter the 7-digit number that appears on the
keyfob sticker and then press to confirm. To complete the enrollment
procedure, see Note 9 in the Additional Information table below.
ID ACCEPTED
If a valid ID was entered, a "Happy Tune" ☺ sounds and the display reads
[ID ACCEPTED] for a short duration and then changes to read the keyfob's details.
Continue to step 5.
☺ Go to step 5
5.
F01:keyfob
ID No. 300-5786
The display shows the allocated keyfob serial No (user No.), which is always the
first free number, and the keyfob's ID number; for example:
[F01:Keyfob] alternating with [ID No. 300-5786].
or
To assign the keyfob to another user, for example, "User No. 5", key in [05] or
alternatively click the or button until the display reads [F05:Keyfob]
and then press to confirm.
F05:keyfob
☺ Return to step 2
The display reads [ DEVICE ENROLLED ] or [ ID accepted ] if the keyfob was
enrolled manually by entering the ID number, a "Happy Tune" ☺ sounds and
the display will then change to [ F01:Keyfob ].
5 6