Visonic PowerMaster-10 G2 User Guide

OPERATING THE POWERMASTER SYSTEM
D-304829 PowerMaster-10/30 G2 User's Guide 13
Initiating Fire Alarm
1
or Emergency Alarm
You can generate a fire alarm or a silent emergency alarm in disarmed & armed states, as follows:
PRESS RESULTING DISPLAY
FIRE ALARM
OR
EMERGENCY
for 2 seconds
Then, if or when the system is
in the disarmed state:
READY HH:MM
(alternating)
READY MEMORY
To stop the alarm, press and then key in your valid user code.
Note: For UL Listed product, Emergency is ancillary use only.
Chime ON/OFF
Disable / enable the chime zones (see Appendix C) by alternate clicking of the key, as shown below:
PRESS RESULTING DISPLAY
CHIME ON
CHIME OFF
↓
READY HH:MM
CHIME indicator lights steadily when “chime on” is selected.
Note: For UL Listed Product, the Chime setting must be set to “Chime ON”.
Adjusting the Speech Volume
2
and the Volume of the Keypad Beeps
The following diagrams show how to increase or decrease the loudness by clicking the <1> or<4> key
(assuming that the volume was at minimum/maximum to begin with).
PRESS RESULTING DISPLAY PRESS RESULTING DISPLAY
VOLUME+
(max)
VOLUME–
VOLUME+
VOLUME–
VOLUME+
VOLUME–
(max)
VOLUME+
VOLUME–
1
This function is disabled in ACPO compliant version
2
Refers to PowerMaster-30 G2 with voice option only

Visonic PowerMaster-10 G2 Specifications

General

Model	PowerMaster-10 G2
Category	Security System
Wireless Technology	PowerG
Remote Control	Yes
Event Log	1000 events
Communication	GSM, PSTN, IP
Frequency	868 MHz
Type	Wireless
Operating Temperature	-10°C to +55°C
Humidity	Up to 85% non-condensing