Visonic PowerMaster-10 G2 - 5.9.4 Testing the SIM Number; 5.9.5 Testing the Broadband;PowerLink Module

APPENDICES
D-304829 PowerMaster-10/30 G2 User's Guide 59
APPENDIX A. FUNCTIONS OF CONTROLLING DEVICES
A1. KP-160 PG2
Arming and Disarming the System
Step
Operation
User Actions
Keyboard & Panel
Response
Optional
1
Select a PARTITION
(if Partition is enabled)
Any combination of
The selected key blinks.
2
Arm AWAY
+ [ ]
The selected key and the
"Present Prox Tag" icon
( ) begin to blink and
prompt you to present
your Tag.
The keyprox's LED blinks
red once to indicate
transmission of the
arming command to the
control panel.
The LED and the buzzer
then indicate the control
panel's response – see
KP-160 PG2 User's Guide,
“System Status and
Indications” section 3.3.
Arm HOME
+ [ ]
Disarm (OFF)
+ [ ]
Optional
3
Quick arm AWAY
(If Quick Arm is enabled)
(≈ 2 sec.)
Quick arm HOME
(If Quick Arm is enabled)
(≈ 2 sec.)
Optional
4
INSTANT (After arming HOME/
AWAY)
LATCHKEY
(After arming AWAY)
Initiating Alarms
Alarms
Actions
Response
Notes
Emergency alarm
(≈ 2 sec.)
See section
3.3. in KP-160
PG2 User's
Guide
When pressing the Fire or Emergency icons, the
KP-160 PG2 starts beeping. After pressing the
button for approx. 2 seconds, the KP-160 PG2
sends the command.
Fire alarm
(≈ 2 sec.)
Panic alarm
(≈ 2 sec.)
When pressing the Fire and Emergency icons
together, the KP-160 PG2 starts beeping. After
pressing the button for approx. 2 seconds, the
KP-160 PG2 sends the Panic command.
Zone Status
Alarms
Response
Notes
For NOT READY ( ) /
BYPASSED ( )
Upon each press of the key, the next zone number
appears on the zone # display, .
Zone Status when working with Partitions
Alarms
Response
Notes
For NOT READY ( ) /
BYPASSED ( )
/ /
Upon each press of the key, the next zone number
assigned to the pressed Partition number appears on the
zone # display, .