Visonic PowerMaster-10 G2 - Setting the Time & Time Format

MENUS AND FUNCTIONS
32 D-304829 PowerMaster-10/30 G2 User's Guide
B.8 Setting the Time & Time Format
♦ Here you can program or adjust the built-in-clock to show the correct time in the desired time format.
♦ You can select between a 24 hour and a 12 hour (AM/PM) time format.

Carefully read the section titled "Additional Information" according to the indicated references
1
etc – see
table at end of this section.
A. To Set the Time Format
1.
TIME & FORMAT
Enter the [USER SETTINGS] menu and select the [TIME & FORMAT] option
and press .
1
2.
US FORMAT 12H 


The display shows the currently selected time format.
2
or
Click the or button until the display shows the desired time
format, for example, "EU FORMAT-24H" and press to confirm .
EU FORMAT-24H
3.
B. To Set the Time
5
4.
TIME 12:40P At the blinking cursor position, enter the correct time, for example, “8:55A”,
using the numerical keypad.
3 4
5.
When you are satisfied with the setting, press to confirm.
TIME 08:55A
A "Happy Tune"  ☺ sounds, the display reads the set time, returns to step 2
and then reads the selected time format.
6, 7
 ☺ Return to step 2
Additional Information (section B.8)
1
For detailed instructions on how to select User Settings – refer to sections A.1 and A.2..
2
a. The display shows the currently selected format (indicated by a

symbol), for example, " 24 Hrs ".
b. You can now select either the 12 Hrs or 24 Hrs time format using the or buttons.
3
The display shows the Time in the selected Time Format, for example, " 12:40 PM ", with the cursor
blinking on the first hour digit "1". The letter that follows the displayed time indicates one of the following:
"A" = AM; "P" = PM and "none" for 24 Hrs time format.
When the curser is positioned on the AM/PM digit, you can set to "AM" with the button and the
"PM" with the
button
4
You can move the cursor to the next or previous digit using the or buttons.
5
This setting can be performed only after completing steps 1 – 3 of section B.8A.
6
The time saved is displayed without the cursor, for example, " 08:55 A " followed by the selected time
format.
7
You can now select another option in the User Settings menu (see section A.1 and section A.2), or quit
programming (see section A.3).