Visonic PowerMaster-10 G2 - 3 Speech and Sound Control; Speech & Sound Cont. Push-Buttons; Voice ON;OFF; Message Exchange

SPEECH AND SOUND CONTROL
14 D-304829 PowerMaster-10/30 G2 User's Guide
3. Speech and Sound Control
1
Speech & Sound Cont. Push-buttons
The sound and speech-related functions offered by the control panel are controlled with the keypad, as detailed
in the following list.
When partitioning is enabled:
Sound and speech-related features only apply to the partition(s) where the control panel is present. An activity
performed via the control panel from another partition will be displayed and the LED will light. The operation will
be added to the log file but will not be heard over the control panel speaker.
Key Function
Increases the loudness of spoken messages
Decreases the loudness of spoken messages
Enables / disables the loudspeaker
Records a spoken message for other users of the alarm system
Allows listening to a recorded message left by another user of the alarm system
Enables / disables the chime function in chime zones
Voice ON/OFF
You can switch spoken announcements on and off by alternate clicking of the <7> key, as shown below.
PRESS RESULTING DISPLAY
VOICE ON
VOICE OFF
↓
READY HH:MM
Note: The system will maintain the “Voice OFF” state until subsequent selection of “Voice ON’.
Message Exchange
For message exchange you can record a verbal message for other users of the alarm system. Face the panel,
press <2> and keep it pressed. When the display reads TALK NOW, start talking. The 5 dark boxes will slowly
disappear one by one, from right to left, as shown in the diagram below.
ACTION RESULTING DISPLAY
(constant)
RECORD A MESSAGE
Talk ↓
TALK NOW
Talk ↓
TALK NOW
Talk ↓
TALK NOW
Talk ↓
TALK NOW
Talk ↓
TALK NOW
Stop talking
RECORDING ENDED
1
Refers to PowerMaster-30 G2 with voice option only