APPENDICES
60 D-304829 PowerMaster-10/30 G2 User's Guide
A2. KP-140/141 PG2
Arming and Disarming the System
Step Basic Arming User Actions Keypad & Panel Response
1
Select a PARTITION
(Partition enabled)
or or
The selected button lights.
2
Arm AWAY
The selected button starts blinking
and prompts you to enter your
"User Code" or present your Tag.
See step 3.
Arm HOME
Disarm (OFF)
Quick arm AWAY
(≈ 2 sec.)
The keypad's LED blinks red once
to indicate transmission of the
arming command to the control
panel. The control panel's
response is then indicated on the
keypad via the LED and the
buzzer – see KP-140 PG2 User's
Guide, “Panel Response to
Keypad Commands” section 3.5
Quick arm HOME
(≈ 2 sec.)
3
Enter USER CODE or
present Proximity TAG.
[USER CODE] or [present TAG]
[DURESS CODE] (2580 by default)
4
INSTANT
(After arming HOME/ AWAY)
The keypad's LED blinks red once
to indicate transmission of the
command to the control panel. The
control panel's response is then
indicated on the keypad via the
LED and the buzzer – see KP-140
PG2 User's Guide, “Panel
Response to Keypad
LATCHKEY
(After arming AWAY)
Automation
Output Function Actions Response
PGM device ON
[PGM
00]
The keypad's LED blinks
red once to indicate
transmission of the
command to the control
panel. The control panel's
response is indicated on the
keypad via the LED and the
buzzer – see KP-140 PG2
User's Guide, “Panel
Response to Keypad
Commands” section 3.5.
PGM device OFF
[PGM
00]
PGM device TOGGLE
[PGM
00]
Initiating Alarms
Other Functions
Alarm Actions Response Function User Actions Response
Emergency
alarm
(≈ 2 sec.)
See KP-140
PG2 User's
Guide, “Panel
Response to
Keypad
Commands”
section 3.5
AUX Function
(see Note)
See section
3.5 of KP-140
PG2 User's
Guide.
Fire alarm
(≈ 2 sec.)
STATUS
indication
See section
3.6 of KP-140
PG2 User's
Guide.
Panic alarm
(≈ 2 sec.)
Note: For the AUX button configuration, see the
KP-140 PG2 Installation Instructions.
To Next Page
Loading...
