Visonic PowerMaster-10 G2 - 5. PROGRAMMING; 5.1 General Guidance; 5.1.1 Navigation; 5.1.2 Feedback Sounds

MENUS AND FUNCTIONS
26 D-304829 PowerMaster-10/30 G2 User's Guide
A. To Program a User Code
B. To Set Partitions Authorization
*
Additional Information (section B.4)
1
For detailed instructions on how to select the setting options – refer to sections A.1 and A.2.
2
The display shows the 1
st
User Code (Master User) in the list of 8 User Codes (in PowerMaster-10 G2
system) / 48 User Codes (in PowerMaster-30 G2). If you have not yet changed the default code 1111, we
recommend that you change it now.
3
a. The display shows the user code currently programmed in this location (e.g. 5327).
b. The cursor blinks on the first digit of the code.
c. If the location is free the display will be blank ( - - - - ).
4
You can move the cursor to the next or previous digit by pressing or . Pressing
erases the digit of the cursor + all digits right of the cursor.
5
a. The new code is momentarily displayed without the cursor before reverting to step 3.
b. If Partition is enabled, continue to step 6.
6
You can now repeat steps 3 - 5 to program or edit another user code. To end this session and to select
other menu options or to quit programming – follow the instructions in section A.2.
7
This setting can be performed only after completing steps 1 - 5 of section B.4A.
8
The

symbol now appears next to the newly selected Partitions.
9
You can now repeat steps 3 - 7 to program or edit another user code.
*
When PARTITIONING is enabled.
1.
USER CODES
Enter the [USER SETTINGS] menu, select the [USER CODES] option and
press .
1
2.
User 01 Code 


The first user code "User 01 Code" is displayed.
2
or
At the blinking cursor position, key in the User Code you wish to program , for
example, [06] for user code 6, or alternatively click the or
button until the display reads, [User 06 Code].
3.
User 06 Code 


When the user code you wish to program appears on the display, press
.
4.
User 06 : 

234
To program or edit the code,
at
the blinking cursor position
enter the 4 digit
code
, for example, “
1234
”, using the numerical keypad.
3,
4
5.
When done, press .
User 06 : 1234
 ☺ Return to step 3 A "Happy Tune"  ☺ sounds. The display confirms the saved code.
5, 6
6.
SET PARTITIONS
The display will read [SET PARTITIONS].
7
7.
U06: P1 P2 P3
Use the keypad keys , , to change the status of the
partitions P1, P2 & P3, respectively.
8
U06: P1 P2 P3
When you are satisfied with the setting, for example, User 6 is authorized
with Partition 1 and 3 only, press to confirm.
 ☺ Return to step 3 A "Happy Tune"  ☺ sounds. The display confirms the Partition setting.
9