DLP Projector—User’s Manual
– 9 –
S
ETUP AND
O
PERATION
Starting and Shutting down the Projector
1.
Connect the power cord to the projector.
Connect the other end to a wall outlet.
The
POWER LED on the projector
light.
2.
Turn on the connected devices.
3.
Ensure the POWER LED not a flashing.
Then press the
POWER button to
turn on the projector.
The projector splash screen displays and
connected devices are detected.
See Setting an Access Password
(Security Loc
k) on page 11 if security
lock is enabled.
4.
If more than one input device is
connected, press the SOURCE button
and use ▲▼ to scroll among devices.
(Component is supported through the
RGB to COMPONENT ADAPTER.)
VGA1 / VGA2(*): Analog RGB
Composite Video(*): Traditional composite video
S-Video(*): Super video (Y/C separated)
HDMI(*): High-Definition Multimedia Interface
Note : (*)Not available in some model
To Next Page
Loading...
