Hardware Reset
The reset button is used to reset the system or restore the factory default settings� Sometimes
resetting the system can return the camera to normal operation� If the system problems remain
after rebooting, restore the factory settings and install again�
Reset: Press and release the reset button with a paper clip or thin object� Wait for the Network
Camera to reboot�
Restore: Press and hold the reset button until the status LED rapidly blinks red and green
simultaneously� Note that all settings will be restored to factory default�
SD Card Capacity
This network camera is compliant with SDHC 16GB / 8GB and other preceding standard SD
cards�
Reset Button
Status LED
To Next Page
Loading...
