VIVOTEK
User's Manual - 43
Media > Image
Advanced Mode
This section explains how to configure the image settings of the Network Camera� It is
composed of the following four columns: General settings, Picture settings, Exposure, and
Privacy mask�
General settings
Video title: Enter a name that will be displayed on the title bar of the live video as the picture shown
below�
Show timestamp and video title in videos and snapshots: Select this checkbox if you prefer video
title and time stamp to display in videos and snapshots�
A zoom indicator will be displayed on the Home page when you zoom in/out the live viewing
window as the picture shown below. You may zoom in/out the image by scrolling the mouse
wheel inside the live viewing window, and the maximum zoom in will be up to 4 times.
Video Title
Title and Time
Video 17:08:56 2010/11/25
2012/03/09 17:08:56
X1.1
Zoom Factor
Color: Select to display color or black/white video streams.
Power line frequency: Set the power line frequency consistent with local utility settings to eliminate
image flickering associated with fluorescent lights� Note that after the power line frequency is
changed, you must disconnect and reconnect the power cord of the Network Camera in order for
the new setting to take effect�
Video orientation: Flip--vertically reflect the display of the live video; Mirror--horizontally reflect
the display of the live video� Select both options if the Network Camera is installed upside-down
(e.g., on the ceiling) to correct the image orientation. Please note that if you have congured preset
locations, those locations will be cleared after ip/mirror setting.
To Next Page
Loading...
Need help?
General
