Use Supplied M8 Flat Head Bolt Here
Install Glow Plug Module
This Side Using M6 Bolts
Goes To Stud
On Firewall
Tie Strap Negative Battery Cable Harness Here .
Positive Terminal Lock Nut
Negative Post
Figure 3.19
□ Using a hammer, flatten the raised, rolled edge around the
fender sub frame to provide clearance for the glow plug bracket.
□ Connect the three connectors to the glow plug module.
□ Install glow plug bracket. Use supplied M6 nut to secure the
back leg to the stud on the firewall, (Figure 3.19).
□ Use supplied M8 flat head bolt to hold the long leg of the glow
plug bracket to the fender sub frame, but DO NOT TIGHTEN at
this point.(Figure 3.19).
To Next Page
Loading...
