Hose Information
Depending on other installed equipment, it might be
necessary to move the air/oil separation tank from its
intended location. The hoses used in VMAC compressor
systems have a specific inner liner that is compatible with
our compressor oil. Use of hoses other than those supplied
or recommended by VMAC may cause compressor damage
and may void your warranty. Please contact VMAC for
replacement hoses and further information.
Part 1: Warranty and System ID
□ Complete the warranty form. The VMAC warranty form is located
at the back of this manual. This warranty form must be
completed and mailed or faxed to VMAC at the time of
installation for any subsequent warranty claim to be considered
valid.
System Identification and Operating Instructions
The System Identification Number Plate must be attached to the
vehicle at the time of installation. This plate provides information that
allows VMAC to assist in customer inquiries and the ordering of
parts.
□ Mark and drill two 7/64” holes in the top of the cross member in
front of the OEM air filter box. Secure the plate with supplied
self-tapping screws
□ Clean cross member beside the number plate and stick the
VMAC belt routing diagram to the cross member.
□ Apply battery warning label to driver side of primary cooling
reservoir.
To Next Page
Loading...
