Part 6: Finishing the Installation
6.1 Before Starting the Engine Checklist
Make sure that the following have been completed:
□ Check the vehicle coolant.
□ Check the compressor oil level.
□ Do a final inspection to make sure that everything has been
completed and tightened.
□ Perform a final belt alignment check.
□ Check all wiring for security and protection.
□ Check all wiring and in-cab installed electronics keep away from,
and do not interfere with, the operation of the park brake
mechanism, brake & accelerator pedals, and steering column.
6.2 Safety Test
Place the vehicle in a safe operating position and block the
wheels. Ensure that there are no people around the vehicle
before beginning the test.
If the vehicle fails the test, check the wiring to make sure
that all the connections are correct and secure. If you
require additional assistance, contact your local VMAC
dealer. Call 1-888-241-2289 or 250-740-3200.
□ Install a test tool on the air tank outlet and close the ball valve.
□ Place the automatic transmission in Park and apply the park
brake. Turn the ignition key “ON” but do not start the engine.
To Next Page
Loading...
