Figure 3.25
□ Route 1" fill hose down beside radiator on the passenger side from
inside engine bay to washer bottle location and attach to washer
bottle using hose clamp (Figure 3.25).
□ Attach washer hose and electrical connector to pump.
□ Install washer bottle with carriage bolts going through bumper
support. Secure with supplied M10 nuts and torque to
specifications.
□ Install washer bottle fill fitting to top of 1" hose and secure with hose
clamp (Figure 3.25).
□ Remove rubber from provided P-Clip. Using P-Clip secure fill hose
to bolt holding on fan shroud. Hose should be close to radiator on
driver’s side of the bolt, and next to bolt facing rear of truck.
□ Fill washer bottle with saved washer fluid.
Water Bottle Installation with Fog Lights: To install the
water bottle, the passenger side fog light mount must be
modified. See below.
□ First remove the bumper support bracket as described as in above
text, then disconnect the fog light wiring harness at the right fog
light.
To Next Page
Loading...
