26 Attendant Features
Attendant Override
When Attendant Override is enabled, Attendant stations may override
or call stations that are busy or in Do Not Disturb.
To call a station busy on a CO call:
Press the preprogrammed ATTN OVERRIDE button [601]. Three short
tone bursts are presented to the called party.
After five (5) seconds, the station’s CO line is automatically placed
on hold and the Attendant is cut-through.
To call a station in Do Not Disturb mode:
Press the preprogrammed ATTN OVERRIDE button. The station is
signaled with a Camp On tone.
Attendant Setting Time and Date
System Time/Date must be set by the first programmed Attendant via
admin programming or using feature code 692.
To set using the feature code:
1. Dial [692] on the dial pad. A confirmation tone will sound.
2. Enter date and time as follows: YYMMDDHHMM
When the correct number of digits are entered, a confirmation tone
will sound.
3. Press the ON/OFF button (SPEAKER button on IP Phone) to OFF to
update the display.
YY = Year (00-99) HH = Hour (00-23)
MM = Month (01-12) MM = Minute (00-59)
DD = Day (01-31)
To Next Page
Loading...
