54 Conference
To re-enter a Conference:
When the controller re-enters the conference, the disconnect timer is
reset.
1. Lift the handset to re-enter a monitored conference.
2. To re-enter a conference placed on hold, repeat the steps for
establishing a conference.
3. To re-enter an unsupervised conference, lift the handset and press
the flashing CONF button or use the Soft Key’s RE-ENTER option.
The CONF button will light steady and a confirmation tone will
sound.
To terminate a Conference, the conference initiator who is
actively in the conference must:
Replace the handset or press the ON/OFF button (SPEAKER button
on IP Phone) to OFF.
To terminate an Unsupervised Conference:
Press the flashing CONF button or use the Soft Key’s END option
while on-hook, all parties will be dropped.
To terminate a party during a Conference call:
1. Press the line button of the party you wish to drop.
2. Replace the handset, or press the ON/OFF button (SPEAKER button
on IP Phone).
3. Lift the handset, or press the ON/OFF button (SPEAKER button on IP
Phone).
4. Press the flashing CONF button.