8 Operating elements
(see fold-out page)
Receiver LSG-10
1� Sensor prod
2� LED torch
3� Display
4� NCV button for switching between cable detection mode and contact-free AC voltage detection
5� Torch on/off button (off automatically after approx� 1 min�)
6� Down button for manual sensitivity settings
7� MODE buttons for toggling between automatic and manual mode
8� Button for switching the beep sound and display illumination on and off
9� Up button for manual sensitivity settings
10� Operating button (On/Off)
11� Battery compartment on the rear
Receiver display LSG-10
a� Signal strength bar display
b� Grid voltage indication
c� Display for manual sensitivity selection
d� Transmission code display
e� Signal level (I, II or Ill) display
f� Acoustic display is deactivated
g� Signal strength display
h� Sensitivity display (isolation symbols: many arches = low sensitivity; few arches = high sensitivity)
i� Display for active display illumination
j� Display for automated sensitivity selection
k� Battery state display (4 bars = battery full; <1 bar = battery empty)
l� Display for contact-free AC voltage detection
Transmitter LSG-10B
12� “Phase/+” connection socket
13� Connection socket reference potential (earth)
14� Display
15� Button for signal level settings (level I, II or Ill) and display illumination (press for 2s)
16� Operating button (On/Off)
17� Battery compartment on the rear
33
To Next Page
Loading...
