41
8. Display elements and symbols
The following symbols and letters appear on the device/display.
1 Automatic power-off is enabled
2 Automatic range selection is enabled
3 Diode test symbol
4 Continuity test symbol
5 Maximum value
6 Minimum value symbol
7 Symbol for active data hold function
8 Delta symbol for relative measurement
(= reference measurement)
9 Low-pass lter symbol
10 Battery status indicator
11 V = Volt (unit of electrical voltage), mV = Millivolt (exp.-3)
A = Ampere (unit of electric current)
12 Temperature unit (°Celsius = European, °Fahrenheit = empirical)
13 Symbol for measuring frequency and pulse duration ratio in %
14 Measured value
15 Bar graph display with sign for negative measured values
16 Alternating current symbol
17 Prex for negative readings
18 Direct current symbol
19 nF = Nanofarad (exp.-9, unit of electrical capacity)
= µF Microfarad (exp.-6)
20 Low impedance symbol
21 Ω = Ohm (unit of electrical resistance),
kΩ = Kilo-Ohm (exp.3),
MΩ = Mega-Ohm (exp.6)
OFF Move to this position to turn the multimeter off
NCV Contactless AC voltage detection (V-AC only)
True RMS Actual effective value
HOLD Enable/disable data hold function
MAX MIN Button for Max-Min function
REL Make a relative measurement and set the reference value (not possible for continuity tests, diode
tests, frequency and NCV measurements)
RANGE Use this button to manually select the measurement range
To Next Page
Loading...
