Emergency stop switch
NOTICE
Risk of machine damage.
Using the emergency stop can damage the machine systems.
Use the emergency stop only in emergency situations. In all other
situations, use the ignition switch to stop the machine.
There is an emergency stop button inside the cab (see page
123
)
on the right instrument panel. When it is pressed, the machine's
engine turns off immediately. Another emergency stop button is
also available (optional equipment) for installation on the left front
fender at the cab entrance. In such cases, both emergency stop
buttons are connected in series, that is, only one of them has to be
pressed to turn off the engine.
Restoring
To restore the emergency stops so that the machine can be
operated again, turn the emergency stop button clockwise until it
pops out.
Auto engine shutoff
(Optional equipment)
The machine may be equipped with automatic engine shut-down.
This means that the engine is turned off automatically and the
parking brake is activated if the engine has idled for four minutes
and other conditions for automatic shut-down are fulfilled, see
below. The time for idle before the engine is turned off can be
changed with the authorized service tool.
When 60 seconds of the time remains, the operator is informed by
an amber alarm display figure and then the operator has the
possibility to cancel the function by pressing the keypad's ESC-
key.
The countdown starts if the following conditions are fulfilled:
- increased engine rpm is not activated
- accelerator pedal not pressed
- gear selector in neutral position (N-position)
- delayed shutdown is not activated
- brake test not in progress
- regeneration not in progress
- load body not being raised or lowered
- machine not moving
- machine longitudinal inclination is less than 7%
- control light for alternator charging failure not on
- hydraulic oil temperature above 20 °C (68 °F)
- transmission oil temperature above 20 °C (68 °F)
- ambient temperature above -10 °C (14 °F) and below 40 °C
(104 °F)
1 2
5
8
0
3
4 6
7
SETUP
9
ESC
SELEC T
24 V
0
1
V1092149
r / min
STOP
1. Emergency button, position on instrument panel
in cab
1. Extra emergency stop button on left front fender
(optional equipment)
Operating instructions
Stopping
205
To Next Page
