Maintenance
This section describes maintenance and service jobs that the
operator can do. Other maintenance and service jobs should be
performed by a qualified service technician.
The page
304
presents all the jobs and actions that are included
in the machine's service program. This page also makes it clear
which jobs in the service program can be done by the operator,
and which ones should be performed by a qualified service
technician.
Emission control system
The emission control systems for your new Volvo Construction
Equipment engine have been designed, manufactured, and
tested using genuine parts, and they have been certified
according to American federal and California regulations on
emission control. According to these all spare parts that are to be
used for maintenance, repairs, or replacement of emission control
systems shall be parts from Volvo Construction Equipment. The
owner may let any qualified service technician perform
maintenance, replacement, or repair of emission control
components and systems that have been certified by the US
Environmental Protection Agency. The owner may choose to use
other parts than genuine Volvo Construction Equipment parts for
such maintenance, replacement, or repair without the warranty
becoming invalid, but the warranty does not cover the cost of such
services or parts.
Service history
After each completed service by a qualified service technician, the
service history should be filled in, see page
444
. Service history is
a valuable document, which is referred to when selling the
machine.
Arrival Inspection
Before the machine leaves the factory, it is tested and adjusted.
The dealer or distributor must also carry out arrival inspections
according to the applicable form.
Delivery Inspection
Before the machine leaves the factory, it is tested and adjusted.
The dealer or distributor must also carry out delivery inspections
according to the applicable form.
Maintenance
297
To Next Page
