Volvo A30G - Wheels

Wheels
Tyre sizes and pressures
If other tyres are used for than those stated, the tyre manufacturer
should be contacted for information about the correct tyre
pressure.
NOTE!
Avoid mixing tyres with different circumference and with different
type designations on the same axle. This may result in
unnecessary wear of the drivetrain and also change the
machine's characteristics.
NOTE!
Keep in mind that changing to another tyre type requires changes
to the machine's software using the authorized service tool.
NOTE!
For machine with On-Board Weighing (optional equipment), the
equipment should be checked in connection with changing a
wheel. Check the cable and its attaching points, as well as the
load cell.
see page 382
Tyre, specifications (A25)
Applies to models:A25G
NOTE!
The table also includes tires that have been removed from the
range since the machine was introduced.
Tyre inflation pressure at 25,000 kg (55,000 lb)
payload
(a)
A25G
Tyres Front
kPa (psi)
Rear
kPa (psi)
Bridgestone 23.5 R25 VLT 400 (58.0) 450 (65.0)
Bridgestone 23.5 R25 VLTS 400 (58.0) 450 (65.0)
Bridgestone 750/65 R25 VLT 375 (54.5) 400 (58.0)
Bridgestone 750/65 R25 VLTS 375 (54.5) 400 (58.0)
Goodyear 23.5 R25 GP-4D 375 (54.5) 400 (58.0)
Goodyear 23.5 R25 TL-3A+ 375 (54.5) 400 (58.0)
Goodyear 750/65 R25 TL-3A+ 300 (44.0) 325 (47.0)
Michelin 23.5 R25 XADN+ 375 (54.5) 425 (61.5)
Michelin 23.5 R25 XTRA DEF. 325 (47.0) 400 (58.0)
Michelin 23.5 R25 X SUPER TERRAIN+ 375 (54.5) 425 (61.5)
Michelin 750/65 R25 XAD65-1 325 (47.0) 375 (54.5)
Michelin 750/65 R25 XTRA DEF. 275 (40.0) 325 (47.0)
Yokohama 23.5 R25 RT31 375 (54.5) 425 (61.5)
a) The specified load is the maximum load for a standard machine, even on an occasional basis. Rebuilding of the machine or
installation of optional equipment may require a different tyre pressure. If so, approval for use and the recommended tyre
pressure for the changed conditions should be obtained from the tyre supplier.
Specifications
Wheels

419
