Work lights roof
Work lights rear are operated with switch SW3505 located on the
pillar panel.
- Switch upper part pressed in = Work lights cab and radiator
casing on when reverse gear is engaged.
- Switch in middle position = Work lights cab and radiator casing
on.
- Switch lower part pressed in = Work lights off.
Control light on the front instrument panel indicates that work
lights are on.
See
370, Wiring diagram 305
.
For double work lights cab, see
370, Wiring diagram 312
.
Work lights rear, continuous/gear-dependent (optional equip‐
ment)
With this function, it is only possible to select continuous or gear-
dependent engagement of work lights rear.
Selection of function with switch SW3505 located on the pillar
panel.
- Switch upper part pressed in = Work lights cab and radiator
casing on when reverse gear is engaged.
- Switch in middle position = Continuous work lights cab and
radiator casing on.
- Switch lower part pressed in = Continuous work lights cab and
radiator casing on.
Control light on the front instrument panel indicates that work
lights are on.
See
370, Wiring diagram 313
.
Guide lights in switches and lighting in climate control system's
panel
Light intensity for guide lights in switches and lighting in climate
control system's panel are controlled with rheostat R3502.
- Rheostat's upper part pressed in = light intensity increases.
- Rheostat's lower part pressed in = light intensity decreases.
See
370, Wiring diagram 304
.
26
To Next Page
Loading...
