LIGHTING
* Option/accessory.
151
Load case Thumb-
wheel
position
Driver and passenger in the front
passenger seat.
Two passengers in the third seat
row*.
0
Driver and passenger in the front
passenger seat.
Three passengers in the second
seat row.
Two passengers in the third seat
row*.
70 kg load in the cargo area.
1
Related information
•
Lighting control (p. 148)
Position lamps
Position lamps can be used so that other road
users can see the car if it stops or is parked. The
position lamp is switched on with the rotating
ring on the stalk switch.
Stalk switch rotating ring in position lamps position.
Turn the rotating ring to the position - the
position lamps are switched on (number plate
lighting is switched on at the same time).
If the car's electrical system is in ignition position
II or the car is running then the daytime running
lights are switched on instead of the front posi-
tion lamps. When the rotating ring is in this posi-
tion, the position lamps are switched on regard-
less of the ignition position of the car's electrical
system.
If the car is stationary but running, the rotating
ring can be moved to the position lamp
position from another position to switch on only
the position lamps instead of other lighting.
When driving for more than 30 seconds at max.
10 km/h (approx. 6 mph), or if the speed
exceeds 10 km/h (approx. 6 mph), the daytime
running lights are switched on. The driver should
turn to a position other than
.
If the tailgate is opened when it is dark outside,
the rear position lamps come on (if not already
switched on) to warn road users approaching
from behind. This takes place irrespective of the
position of the rotating ring or the ignition posi-
tion of the car's electrical system.
Related information
•
Lighting control (p. 148)
•
Ignition positions (p. 426)
•
Replacing daytime running light bulb/posi-
tion lamp bulb, front (p. 612)
To Next Page
