MAINTENANCE AND SERVICE
}}
607
Lift off the rubber strip by pressing it inward
in the engine compartment.
Detach the flap in the plastic cover by folding
out the release catch and turning the flap
upward.
Screw off the cap and top up with coolant if
necessary. The coolant level must lie
between the MIN and MAX marks on the
expansion tank.
IMPORTANT
•
Mix the coolant with approved quality
water. In the event of any doubt about
water quality, used ready-mixed coolant in
accordance with Volvo recommendations.
•
Make sure that the coolant mixture is
50% water and 50% coolant.
•
Always use coolant with anti-corrosion
agent as recommended by Volvo.
•
Only new coolant should be used when
replacing major cooling system compo-
nents to ensure the system has sufficient
corrosion protection.
•
The engine must only be run with a well-
filled cooling system. Otherwise, tempera-
tures that are too high may occur result-
ing in the risk of damage (cracks) in the
cylinder head.
•
A high content of chlorine, chlorides and
other salts may cause corrosion in the
cooling system.
Related information
•
Engine compartment overview (p. 603)
•
Coolant — specifications (p. 662)
Bulb replacement
The bulb in the halogen headlamp can be
replaced without assistance from a workshop.
Halogen headlamps are not available for all
models and markets. Contact a Volvo retailer for
more information.
An LED
13
type lamp must be replaced by a
workshop. An authorised Volvo workshop is rec-
ommended.
NOTE
For information about bulbs not covered in
this article, contact a Volvo dealer or a certi-
fied Volvo service technician.
The bulb in the halogen headlamp can be
replaced without the help of a workshop, but the
plastic cover over the headlamp must be removed
before a bulb can be replaced.
The dipped beam bulb becomes accessible when
the headlamp's round rubber cover is removed.
Bulbs for direction indicator, main beam and day-
time running light/position lamp are accessible
when the headlamp's oblong cover is loosened.
13
LED (Ligth Emitting Diode)