LIGHTING
153
when the car's electrical system is in igni-
tion position II or when the car is running.
Tunnel detection
The car detects when it is driven into a tunnel
and switches from daytime running lights to
dipped beam.
Note that the rotating ring in the left-hand stalk
switch must be in
mode for tunnel detec-
tion to work.
Related information
•
Lighting control (p. 148)
•
Ignition positions (p. 426)
•
Daytime running lights (p. 152)
•
Replacing the dipped beam bulb (p. 610)
Using main beam
Main beam is operated with the left-hand stalk
switch. Main beam is the car's strongest lighting
and should be used when driving in the dark for
better visibility, as long as it does not dazzle
other road users.
Steering wheel stalk switch with rotating ring.
Main beam flash
Move the stalk switch backwards slightly to
main beam flash position. Main beam comes
on until the stalk switch is released.
Main beam
Main beam can be activated when the steer-
ing wheel stalk switch's rotating ring is in
position
5
or . Activate main
beam by moving the stalk switch forwards.
Deactivate by moving the stalk switch back-
wards.
When main beam has been activated the
symbol illuminates in the driver display.
Related information
•
Lighting control (p. 148)
•
Active main beam (p. 154)
•
Replacing the main beam lamp (p. 611)
5
When dipped beam is activated.
To Next Page
