27
WWW.VORONDESIGN.COM
THREAD INTO PLASTIC AT AN ANGLE
The holes here are designed at an angle.
Go slow. Tighten the FHCS until they are
ush, but do not over tighten.
WHAT ARE THESE FOR?
When you install the toolhead, the bottom of
the toolhead should rest on these screw heads.
FUN FACT
This part has thin voids inside it (blue). When
the part is sliced, these produce internal ribs
which strengthen the part. If your slicer closes
these up, recheck your slicer settings.
(2) M3x6 FHCS (2) M3x6 BHCS
To Next Page
Loading...
