15
2.2 Standby position and power
setting
2.2.1 Setting the device into standby
position
The standby position is used for storing your cordless
vacuum cleaner, when you are not using it or want to
charge it. You can also ‘park’ it in this position if you
want to take a short break while cleaning. In the standby
position, the device stands upright and firmly on the
floor.
You can only put the cordless vacuum cleaner into
standby position when it is centred.
1. This is done by rotating the cordless vacuum cleaner
at the pivot so that both the cordless
vacuum cleaner and accessory head are facing
straight ahead
.
Now you can set it to standby position.
2. Move the handle forward until it is upright and
you hear it click into the pivot
.
If you put the cordless vacuum cleaner with the
electric brush into standby position without having
switched the cordless vacuum cleaner off at the main
switch, the cordless vacuum cleaner will keep running
and the electric brush will switch itself off.
2.2.2 Setting the device into power setting
In the power setting, the cordless vacuum cleaner can
be moved freely and the device can be steered in all
directions on the floor.
1. Hold the accessory head firmly in place with your
foot
and tilt the handle back
so that you hear
the cordless vacuum cleaner disengage from the
standby position.
Now the accessory head can be moved in all direc-
tions again.
1
2
To Next Page
Loading...
Need help?
General
