Vorwerk KOBOLD VB100 - Kobold EBB100 Electric Brush

40
6.2 Kobold EBB100 Electric
Brush
Fault Possible cause and rectication
The Kobold electric brush is too loud. The roller brushes may not be correctly inserted.
• Check whether the roller brushes are correctly inserted.
• Always replace both brushes together.
It may that original Kobold accessories were not used; this
can lead to bearing and motor damage.
• Use original Kobold roller brushes only.
An object may have become stuck in the area of the roller
brushes.
• Remove the object.
There may be loud noises when working on hard oors.
• Switch to ‘normal’ brush mode.
The LED display on the cordless
vacuum cleaner lights up yellow.
The suction duct of the electric brush may be blocked.
• Open the inspection ap
on the underside of the
electric brush.
• Remove the blockage.
• If necessary, use an appropriate object to do this (e.g.
crochet needle).
• Put the inspection ap
back on.