later
Mac: OS X 10.4 or later (Power PC G4 or more/Intel CPU)
Transferring audio data
传递音频数据
SB
can be recorded directly
USB 线缆把 ToneLab ST 连接到了你的电脑，ToneLab ST 的效果器输出
可以直接被录制到你数字音频工作站软件的音频轨。你可以通过 ToneLab ST
监听软件所播放的音频。
need to install the USB-ASIO
driver in your computer in order to transfer audio data via the USB
Download the USB-ASIO driver from the manufacturer’swebsite
Windows：微软 Windows XP SP3/Windows Vista SP1 或者更高版本
Mac：苹果 OS X 10.4 或更高版本（Power PC G4 或更高/Intel CPU）
If the ToneLab ST is connected to your computer via a U
cable, the ToneLab ST’s effect output
into an audio track of your DAW software. You’ll also be able to
monitor the audio playback of your software via the ToneLab ST.
如果通过
就
NOTE: If you’re using Windows, you’ll
connector.
(www.voxamps.com).
注意：如果你使用 Windows 系统，你需要在电脑上安装 USB-ASIO 驱动，从而可
以通过 USB 连接器传输音频数据。
The following illustration shows the signal flow when connected
to your computer.
下面的流程显示了连接到电脑的信号传输过程。
Operating requirements
系统要求
Windows: Microsoft Windows XP SP3/Windows Vista SP1 or
later
Mac: OS X 10.4 or later (Power PC G4 or more/Intel CPU)
To Next Page
Loading...
Need help?
General
