www.vtechphones.com
33
Advanced operation
Answering system operation
During remote
access, if no key
is pressed within
eight seconds,
the remote
access call is
automatically
disconnected.
•
Remote access
You can access many features of your answering system remotely from any touch tone telephone.
A four-digit security code is required to access the system and the factory default code is 0000; see
page 30 to change it. To enter remote access:
• Dial your telephone number from any touch tone telephone.
• When the system answers and plays the outgoing announcement, press
*
followed by the
remote access code.
• After you enter the remote access code, the system will play any new messages and then play
the menu of commands.
0 To end the call
1 To play all messages
2 To play new messages
3 To delete the message
33 To delete all old messages
4 To repeat the previous message
5 To stop playing the message
6 To skip the message
7 To turn the answering system on
8 To turn the answering system off
9 To repeat help
Remote access commands:
To Next Page
Loading...
Need help?
General
