Parent unit battery
It takes up to 11 hours for the battery pack to be fully
charged. When it is fully charged, you can expect the following
performance:
Operation Operating time
While in standby* mode Up to 5 days
While in monitoring** mode Up to 4.5 hours
* The parent unit is not charging or in TALK mode. There is no sound
detected from the baby unit.
** The monitoring time varies depending on the sensitivity level you
set, your actual use and the age of the battery.
The battery needs charging when:
A new battery pack is installed in the parent unit.
The parent unit beeps four times every minute.
The battery pack is properly installed and no battery icon displays
on the screen.
LOW BATTERY and flashes on the parent unit screen.
The light flashes on the parent unit.
CAUTION:
Use Only Supplied Battery.
Do not dispose of the battery pack in a fire. Check with local waste
management codes for special disposal instructions.
Do not open or mutilate the battery pack. Released electrolyte is
corrosive and may cause burns or injury to the eyes or skin. The
electrolyte may be toxic if swallowed.
Exercise care in handling the battery pack in order not to create a
short circuit with conductive materials.
Charge the battery pack provided with or identified for use with
this product only in accordance with the instructions and limitations
specified in this manual.
Observe proper polarity orientation between the battery and
metallic contacts.
To prevent fire or shock hazard, do not expose this product to water
or any type of moisture.
•
•
•
•
•
•
•
•
•
•
•
•
To Next Page
Loading...
