450mA
Baby unit installation
You can power up the baby unit by connecting it to AC power.
Install the baby unit as shown below.
Make sure that the power outlet is not controlled by a wall
switch. Bundle the power adapter cord neatly with a twist tie.
The baby unit turns on when it is powered up.
Use only the power adapters supplied with this product. To
order a replacement, contact VTech on 1 300 369 193.
The adapters are intended to be correctly oriented in a
vertical or floor mount position. The prongs are not
designed to hold the plug in place if it is plugged into a
ceiling, under-the-table or cabinet outlet.
Make sure the unit and the power adapter cord are out of
reach of children.
•
•
•
Power outlet
Power adapter
The POWER
light remains
on when the
baby unit is
turned on.
To Next Page
Loading...
