VTech ES1610A - Install and Charge the Handset Battery; Connect the Charger (For ES1610 A Twin or ES1610-0 A only)

4 5
4 5
2.4 Install and Charge the Handset Battery
Slide open the battery compartment cover.
Place the two AAA batteries as indicated following the polarity
signs.
Slide the battery compartment cover back in position.
4. Put the handset on the base or charger to charge for at least
14 hours for the rst time. A beep sounds when the handset is
properly placed on the base or charger.
NOTEs
Use only the AAA, 1.2V, 400mAh, NiMH rechargeable batteries.
Ensure power cord is fed through the slot on the base so unit
sits ush with the desk.
2.5 Connect the Charger (For ES1610A Twin or
ES1610-0A only)
Plug the power cable into the charger base.
Plug the other end into the power wall socket and switch the
power on.
NOTE
Ensure power cord is fed through the slot on the base so unit sits
ush with the desk.
1.
2.
3.
•
•
1.
2.