VTech Innotab 3S User Manual

31
Touch screen is
inaccurate or it is
impossible to select
the correct icon on the
screen.
Touch screen
requires calibration.
Turn the InnoTab
®
3SOFF.Then
hold
, and down
when turning the InnoTab
®
3SON.
Follow the steps on the screen.
Inserted a microSD
memory card (not
included), but the tablet
cannot recognise it.
microSD memory
card format is not
FAT32.
Format the microSD memory card
to FAT32 in your computer.
Files copied to the
tablet's internal
memory disappeared.
The tablet's memory
was not formatted
to FAT32.
If formatting the memory is
necessary, make sure it is
formatted to FAT32.
Cannot connect to
Wi-Fi.
TheWi-FiisOff. GotoSettings-ParentSettings-
to turn on Wi-Fi.
The firmware of
the InnoTab
®
3S is
not up-to-date or
the tablet has not
been registered on
Learning Lodge
TM
.
RegisteryourtabletonLearning
Lodge
TM
, and make sure the
firmware is the most up-to-date
version. For the instructions,
please see the Preparing to Use
Wi-Fi section on page 9.
Wi-FiisOn,butthere
is no Wi-Fi network
available.
There is no Wi-Fi
network in your
location or network
signal is weak.
Move to a location that has an
available Wi-Fi network.
Wi-Fi network is
available, but the
connection failed.
The selected
network is not
configured properly
or authentication is
required.
Make sure the network is
configured properly and there is no
firewall blocking Internet access. If
a password is needed, make sure
the correct password is entered
withtheappropriateuppercase/
lowercase letters indicated.
When using the
rechargeable battery
packs, the console
suddenly turns off
without prior Low
Batterywarning.
There is uneven
charge storage
among the cells in
the battery packs.
Charge the rechargeable battery
packs for 24 hours (keep charging
even after the battery charging
indicator light stops flashing).

VTech Innotab 3S Specifications

General

Brand	VTech
Model	Innotab 3S
Category	Tablet
Language	English