VTI Instruments EX1629 - Vtex1629_Set_Cal_Out

www.vtiinstruments.com
EX1629 Command Set 239
vtex1629_set_cal_out
FUNCTION PROTOTYPE
ViStatus _VI_FUNC vtex1629_set_cal_out (ViSession vi, ViInt32 outMode);
FUNCTION PARAMETERS
vi = contains a session handle to the instrument. This handle is obtained by the function and remains valid until the
session is closed.
outMode = an integer input value that indicates the desired output of the calibration source. See the Description
section below for more information.
DATA ITEM RESET VALUE
Not applicable to this function.
DESCRIPTION
This function sets the calibration input source to a specified voltage. Possible values for the outMode parameter are:
VTEX1629_CAL_OFF (turns the calibration source off)
VTEX1629_CAL_ON (turns the calibration source on)
VTEX1629_CAL_SHORT (shorts the calibration source jacks)
VTEX1629_CAL_VREF (outputs precision calibration voltage source)
The vtex1629_set_cal_source function is used to configure the precision calibration voltage source.
NOTE This function is intended for factory use only.