www.vtiinstruments.com
EX1629 Web Page Operation 67
SECTION 5
WEB PAGE OPERATION
INTRODUCTION
The EX1629 offers an embedded web page to control network configuration, time configuration,
and firmware upgrades.
OPENING THE WEB PAGE
To open the embedded web page, start the LInC-U utility by navigating to Start → Programs →
VTI Instruments Corporation → LInC-U Utility → LInC-U Utility. Once the utility is run,
LInC-U will scan the network to discover all LAN-based VTI instruments. Once the scan is
complete, the Discovery Devices tab will appear and show the instruments that were discovered,
as shown in Figure 5-1. To open the web page, click on the hostname hyperlink in the Discover
Devices tab. The IP address of the EX1629 can also be viewed from this window as well as its
firmware version.
FIGURE 5-1: LINC-U DISCOVERY TAB WITH EX1629 SELECTED
Alternatively, the IP address of the EX1629 can be entered into the address bar of any web
browser to view the embedded web page. By default, the EX1629 will first attempt to use DHCP
to set its IP Address. If DHCP is not available on the network it is connected to, it will instead use
Auto IP. Determining the Auto IP address is discussed in the Network Configuration discussion in
Section 2. Other discovery methods can be used as well.
To Next Page
Loading...
