VTI Instruments EX1629 - Alphabetical Function Set

VTI Instruments Corp.
98 EX1629 Command Set
ALPHABETICAL FUNCTION SET
The following table provides a summary of the function calls used by the EX1629 along with an
abbreviated description of the function. The pages following this table are function definitions that
provide in-depth detail for each function. A sample function definition is provided immediately
following this table to illustrate what each section of the definition describes.
Command
Description
vtex1629_abort
Aborts data acquisition.
vtex1629_allow_all_channels
Allows the user to include channels that failed
calibration in the scanlist for data acquisition.
vtex1629_break_lock
Releases a lock on the instrument.
vtex1629_check_lock
Queries the lock status of the instrument.
vtex1629_clear_stored_config
Erases the stored configuration from nonvolatile
storage.
vtex1629_close
Closes an instrument programming session.
vtex1629_compare_digests
Compares the two provided digests byte-by-
byte.
vtex1629_dio_clear_event
Clears the DIO event configuration for the
specified inputLine.
vtex1629_dio_clear_events_all
Clears the DIO event configuration for all
events.
vtex1629_disable_logging
Stops the logging of driver calls.
vtex1629_disable_streaming_data
Stops streaming data from instrument.
vtex1629_enable_logging
Allows an application to log messages to a file
for later review.
vtex1629_enable_streaming_data
Starts data streaming from instrument.
vtex1629_enable_streaming_dataEx
Start data streaming from instrument (expert
mode).
vtex1629_erase_teds_data
Erases the data on a TEDS device for one
particular channel.
vtex1629_error_message
Outputs the error message associated with the
statusCode parameter.
vtex1629_findinstr
Scans the LAN for available EX1629
instruments.
vtex1629_get_arm_count
Queries and returns the arm count for the
EX1629.
vtex1629_get_arm_delay
Queries and returns the arm delay for the
EX1629.
vtex1629_get_arm_source
Queries and returns the current setting for the
arm source.
vtex1629_get_bridge_limit
Queries and returns the minimum and maximum
bridge limit values.
vtex1629_get_bridge_limit_enabled
Queries and returns the enabled status of the
bridge limit function.
vtex1629_get_cal_coefficients
Queries and returns the value of a selected
calibration coefficient for one or more channels.
vtex1629_get_cal_file
Reads up to bufferSize characters from the
EX1629 and places them in the XML buffer.
vtex1629_get_cal_file_size
Returns the total buffer size required to read the
cal data.
vtex1629_get_cal_source
Queries and returns the current setting for the
calibration input source.
vtex1629_get_completion_resistor
Queries and returns the mode and the value of
the completion resistor for a specific channel.
vtex1629_get_conf_scanlist
Queries and returns a list of confidence data
values that are currently configured to be
measured and stored with data acquisition.
vtex1629_get_confidence_limit
Queries and retrieves the current confidence
limit settings.