VWR P4 - Functions; Installation; Install and Uninstall VWR Software Multi Wave Pro

28
Software
Functions
We’ll introduce the main functions of VWR Software Multi Wave Pro in this chapter.
Quantitative Analysis
 Provide 2 methods to establish a Standard Curve;
 Up to 20 standard samples to establish a new curve or input the coefficients to make a standard curve;
 There are three methods, which are Linear zero , Linear and Square to fit the standard curve.
Kinetics Analysis
 We can choose the Time Intervals(0.5, 1.0, 2.0, 5.0, 10.0, 30.0 or 60.0 Seconds);
 You can choose different Photometric Mode to display the curve (Transmittance-Time & Absorbance-Time).
Spectrum Scan
 You can choose the Scan Intervals(0.1, 0.2, 0.5, 1.0, 2.0 and 5.0nm);
 You can choose the Photometric Mode to display the spectrum (Wavelength-Transmittance, Wavelength-
Absorbance);
 Automatically list spectrum peaks;
 Mathematics and smooth.
Multi-wavelength Analysis
 Up to 20 wavelengths to measure a sample.
DNA/Protein Analysis
 We provide 2 methods;
 You can input the coefficients by yourself.
Energy Scan
 You can switch the light source point(W Lamp, D2 Lamp or automatically switch);
 You can choose the scanning intervals(0.1,0.2,0.5,1.0,2.0 and 5.0);
 You can set the gain(1 to 8 times);
 Automatically list spectrum peaks;
Installation
We will show you how to install VWR Software Multi Wave Pro on your PC in this chapter.
Install and Uninstall VWR Software Multi Wave Pro
PC System Requirements
 Pentium or above PC;
 CD-ROM;
 USB Ports.
 512MB Memory(1GB or Above is strongly recommended);
 50MB or above hard disc Space;
 Microsoft Windows XP/Vista/7/8/10.
Install VWR Software Multi Wave Pro
1. Put VWR Software Multi Wave Pro disc in the CD-ROM;
2. Double Click to open the CD-ROM, and then, double click Setup.exe which is under the root directory of CD
to start installation , “Welcome” form appear, click Next;