Wacker Neuson BH - Processing Material; Putting out of Operation

Operation
9.2 Processing material
34
Operator’s Manual | BH | 5100056183 | 10/2022 | [en-US]
9.2 Processing material
1
1. Hold the machine with both hands.
2. Put the tool on the material.
3. Push the throttle grip 1 downwards.
4. Press the machine with both hands against the material to be pro-
cessed.
5. Once the material has been machined, lift the machine and move it.
6. When the machine is raised and the throttle grip is depressed, the
engine continues to run at high speed while the percussion mecha-
nism remains engaged.
7. If the tool has no resistance, the percussion mechanism goes to idle
and does not strike any more.
9.3 Putting out of operation
9.3.1 Switch off the machine
1
1. Release throttle grip 1.
2
3
2. Press off button 3.
3. Allow the machine to come to a complete stop.
4. Close fuel cock 2.
5. Place the machine on the back of the hood so it cannot tip over, fall
down or slip.
6. Let the engine cool down.
7. Avoid contact with combustible materials.