Wacker Neuson BH - Table of Contents

Table of Contents
iv
Operator’s Manual | BH | 5100056183 | 10/2022 | [en-US]
Table of Contents
1 EC Declaration of Conformity
2 EC Declaration of conformity
3 Foreword
3.1 Introduction ....................................................................................................................................... 9
3.2 Storage Location of the Operator's Manual ...................................................................................... 9
3.3 Accident Prevention Regulations .................................................................................................... 10
3.4 Contact person................................................................................................................................ 10
3.5 Limitation of liability.........................................................................................................................11
3.6 Use of the operator’s manual..........................................................................................................11
4 Usage
4.1 Designated use ............................................................................................................................... 12
4.2 Unintended use...............................................................................................................................12
5 Safety
5.1 Safety symbols and signal words.................................................................................................... 13
5.2 Principle .......................................................................................................................................... 13
5.3 Structual changes ........................................................................................................................... 14
5.4 Responsibility of the operator ......................................................................................................... 14
5.5 Obligations of the operator.............................................................................................................. 15
5.6 Qualification of staff ........................................................................................................................ 15
5.7 General safety instructions ............................................................................................................. 15
5.8 Safety features................................................................................................................................17
5.9 Maintenance ................................................................................................................................... 18
6 Description of the Machine
6.1 Type plates and labels .................................................................................................................... 20
6.2 Components.................................................................................................................................... 22
6.3 Control elements.............................................................................................................................23
7 Transportation
7.1 Safety instructions for transport ...................................................................................................... 24
7.2 Prerequisites and preparations ....................................................................................................... 24
7.3 Lifting the machine..........................................................................................................................25
7.4 Lashing the machine.......................................................................................................................25
8 Commissioning
8.1 Safety instructions for operation ..................................................................................................... 26
8.2 Tests before commissioning ........................................................................................................... 28
8.3 Putting into operation for the first time ............................................................................................ 28
8.4 Inserting and removing tools...........................................................................................................29
8.5 Setting the machine ........................................................................................................................ 30
8.6 Putting into operation ...................................................................................................................... 30