Rammer Repair Maintenance Schedules
wc_tx001545gb.fm 25
3.6 Periodic Maintenance Schedule (DS 720)
The table below lists basic machine maintenance. Tasks designated
with check marks may be performed by the operator. Tasks
designated with square bullet points require special training and
equipment.
Daily
before
starting
After
first
5
hours
Every
week
or
25 hours
Every
month
or
100 hours
Every 3
months or
300 hours
Every 5
months or
500 hours
Check fuel level.
Check engine oil level.
Check rammer oil level in
sightglass.
Check fuel line, cap and
fittings for cracks or leaks.
Check bellows for damage
and fit.
Tighten ramming shoe
hardware.
Check external hardware.
Clean engine cooling fins.
Change engine oil.*
Clean engine oil filter.*
Clean recoil starter.
Change ramming system
oil.*
Inspect crane lifting cable for
wear, damage, or abuse.
Check and adjust valve
clearance.**
Replace engine oil filter.
Check fuel filter, clean or
replace.
* Perform initially after first 50 hours of operation.
** Perform initially after first 25 hours of operation.
Note: If engine performance is poor, check, clean, and replace air filter elements as needed.
To Next Page
Loading...
Need help?
General
