Maintenance Schedules Rammer Repair
22 wc_tx001545gb.fm
3.4 Periodic Maintenance Schedule (BS 500/600/700-oi)
The table below lists basic machine maintenance. Tasks designated
with check marks may be performed by the operator. Tasks
designated with square bullet points require special training and
equipment.
Daily
before
starting
After
first
5
hours
Every
week
or 25
hours
Every
month
or 100
hours
Every
3 months
or 300
hours
Every
Year
Check fuel level.
Inspect air filter. Replace as
needed.
Check engine oil level.
Check ramming system oil level
in sightglass.
Check fuel line and fittings for
cracks or leaks.
Tighten ramming shoe hardware.
Check engine cylinder screws.
Check external hardware.
Clean engine cooling fins.
Clean and check spark plug gap.
Replace spark plug.
Clean recoil starter.
Change ramming system oil.*
Clean engine muffler and
exhaust port.
Inspect crane lifting cable for
wear, damage, or abuse.
Inspect fuel filter. Inspect oil filter.
* Change ramming system oil after first 50 hours of operation.
Note: If engine performance is poor, check, clean, and replace air filter elements as needed.
To Next Page
Loading...
Need help?
General
