Rammer Repair Maintenance Schedules
wc_tx001545gb.fm 21
3.3 Periodic Maintenance Schedule (BS 50/60/70-2i)
The table below lists basic machine maintenance. Tasks designated
with check marks may be performed by the operator. Tasks
designated with square bullet points require special training and
equipment.
Daily
before
starting
After
first
5
hours
Every
week
or 25
hours
Every
month
or 100
hours
Every
3 months
or 300
hours
Every
Year
Check fuel level.
3
Check engine oil level.
3
Check air filter indicator. Replace as
needed.
3
Check ramming system oil level in
sightglass.
3
Check fuel line and fittings for cracks or
leaks. Replace as needed.
Tighten ramming shoe hardware.
Check engine cylinder screws.
Check external hardware.
33
Clean engine cooling fins.
3
Clean and check spark plug gap.
Replace spark plug.
Clean recoil starter.
3
Change ramming system oil.*
Clean engine muffler and exhaust port.
Inspect lifting cable for wear, damage,
or abuse.
Inspect fuel filter.
3
* Change ramming system oil after first 50 hours of operation.
Note: If engine performance is poor, check, clean, and replace air filter elements as needed.
To Next Page
Loading...
Need help?
General
