Wacker Neuson BS 50-4 Repair Manual

Repair Engine and Upper Machine Components
wc_tx001546gb.fm 47
4.10 Shock Mounts
See Graphic: wc_gr003705
Recommended Tools
Ratchet Wrench
Torque Wrench
Loctite 243 (blue)
4.10.1 Remove the silencing cover, the air cleaner, and the guide handle.
4.10.2 Inspect the shock mounts (a) and make sure that they are securely
mounted to the crankcase. Replace the shock mounts if they are torn
or damaged.
4.10.3 Remove the four socket head cap screws (b) that hold the shock
mounts to the crankcase. On Rammers with guards, remove the
guards (c) from the crankcase. Then, remove the screws that hold the
shock mounts to the guard. When reinstalling the shock mounts, apply
Loctite 243 or an equivalent to the screws and torque them to 34 Nm
(25 ft.lbs.).
Note: Replace the shock mounts as a set. Check the shock mount
screws after the first five hours of operation and tighten them if
necessary.

Wacker Neuson BS 50-4 Specifications

General

Engine Manufacturer	Honda
Stroke Height	65 mm
Fuel Type	Gasoline
Centrifugal Force	15 kN
Sound Pressure Level	92 dB(A)
Sound Power Level	105 dB(A)
Height	965 mm
Ramming Shoe Size	280 mm
Tank Capacity	3.1 l
Fuel Tank Capacity	3.1 l
Engine Type	4-cycle, single-cylinder, air-cooled
Percussion Rate	680 blows/min